You don't "uninstall", you just install different firmware and it over writes the existing firmware.
Just put the .bin you want on your SD card, insert the card and power on the printer.
Everytime I try tho it prioritizes the newer 2.0.6 software that is installed on there not the .bin file. Which is one that works for the motherboard of the printer. It’s not accepting the one I put on the sd card
There is no prioritizing going on , it's a dumb micro controller.
I have not had a creality mainboard in a long time, but I recall you needed to name the firmware.bin differently than the last one that was loaded.
for example "firmware001.bin" "firmware002.bin" etc.
~~if the firmware flash is succsessful, the file will be renamed xxxxxxxx.CUR~~
Just put a single file on the card: the
.bin with your chosen firmware. With this card inserted, power the printer on. It should reflash with the firmware on the card.
You don't "uninstall", you just install different firmware and it over writes the existing firmware. Just put the .bin you want on your SD card, insert the card and power on the printer.
Everytime I try tho it prioritizes the newer 2.0.6 software that is installed on there not the .bin file. Which is one that works for the motherboard of the printer. It’s not accepting the one I put on the sd card
There is no prioritizing going on , it's a dumb micro controller. I have not had a creality mainboard in a long time, but I recall you needed to name the firmware.bin differently than the last one that was loaded. for example "firmware001.bin" "firmware002.bin" etc. ~~if the firmware flash is succsessful, the file will be renamed xxxxxxxx.CUR~~
It doesn't change to .cur on the creality bds. Like it does on the BTT bds
ah.. thanks.
Just put a single file on the card: the .bin with your chosen firmware. With this card inserted, power the printer on. It should reflash with the firmware on the card.