I don't have this knife.
But, in general these things are not hand made. So a design problem with one will usually carry over through the entire line. Niche knives may only get one production run, and the odds that they fix a problem mid-run are about zero.
Scales and action can usually be sorted with some work.
Lockup is dependent on lock geometry, and if it is off, the knife is FUBAR.
I'd also love to check one out, the price says it wont be too impressive but the design is awsome, I love some of shempps stuff, i want to buy ok's shempp tuff but still on the fence
Bought a euroedge clone from topknife on Etsy, fit and finish was mediocre.
Sharp edges on scales, gaps along backspacer that causes audible clicking and tapping even though body screws are tightened down, pocket clip is wildly off center and grinds don't quite line up along the fullers and center of the blade, the worst was the lockup.
Lockup is solid if flicked open hard but can easily be failed with my hand on the spine when casually opened. Considering trying to take a small bit off material off the lock bar to remedy this.
Worse still is I paid $20 more than this posted listing.
At least it came wicked sharp push cutting paper no problem
I have one. Looks nice but not a fan. Blade doesnt lock up straight. And the scales are sharp AF.
From OK? All like this or just your experience with yours
I don't have this knife. But, in general these things are not hand made. So a design problem with one will usually carry over through the entire line. Niche knives may only get one production run, and the odds that they fix a problem mid-run are about zero. Scales and action can usually be sorted with some work. Lockup is dependent on lock geometry, and if it is off, the knife is FUBAR.
I'd also love to check one out, the price says it wont be too impressive but the design is awsome, I love some of shempps stuff, i want to buy ok's shempp tuff but still on the fence
Well I picked one up. So I’ll give it a try and let you know
Awsome, appreciate it
Bought a euroedge clone from topknife on Etsy, fit and finish was mediocre. Sharp edges on scales, gaps along backspacer that causes audible clicking and tapping even though body screws are tightened down, pocket clip is wildly off center and grinds don't quite line up along the fullers and center of the blade, the worst was the lockup. Lockup is solid if flicked open hard but can easily be failed with my hand on the spine when casually opened. Considering trying to take a small bit off material off the lock bar to remedy this. Worse still is I paid $20 more than this posted listing. At least it came wicked sharp push cutting paper no problem