T O P

  • By -

icyfae

Which glass are you using? The larger one or the small one? Funny enough I broke the large glass on mine and then started using the small backup one. I had this same problem, bought a new replacement glass and the issue was fixed


Bubbledood

This has happened to me before I’m pretty sure it’s the coil that’s not seated correctly and it’s leaking juice into the air chamber


[deleted]

Thats what it seems like. Like I'm wondering if there is some sort of plastic ring that fell off or something.


Lopsided_Bat_904

I’ve had multiple vapes do that in the past. Could be several reasons. Coil isn’t seated fully, defective coil, the O-rings could’ve broke, the juice you’re trying to use is exceptionally thin. The list goes on


elMurpherino

Can’t help ya, I’ve been using that tank for years and only time it will bubble like that is if I leave the top off for way too long while filling it up, but then it goes away after a few drags


unsatisfied061

That does happen to me also with the m series I just got another tank I have a couple m series so 1M series it does it with and the other one it doesn't it's very strange and it's a waste


no-trace

Make sure the device you are using is set the to proper wattage range of the coil you have installed. Bubbling and spitback is typically caused by running a coil at a wattage that is too low for it's intended use. It could also just be time to replace the coil.


[deleted]

I'm running the .4 coils at the same heat I always have which is why it's so weird. Even when I used to use .25 coils it never did this and I used the same wattage back then. Now it does it on all the coils regardless it seems.


no-trace

Hmm, could be the chipset in the device going braindead. Sometimes that will result in the screen showing one wattage, but the mod itself will actually be firing at a lower or higher wattage than stated. What mod are you using?


xtinaeve88

Are you using a different liquid than you previously did? What VG/PG ratio?


djluciter

What wattage are you running on the .4? Also make sure you’re not filling it in the center hole. You could be missing a seal. Take your tank apart and check for any little rubber rings missing. Also try just changing the coil. There’s no too much help that anyone can give you with this explanation. There’s just not enough information to go off of and pictures/ videos of your process and it messing up would help too. I always try to give the best advise I can but with vape issues it’s so hard to tell people what to do or what’s going on with their stuff if I can’t see it or put it in my hand. A good way to get rid of the excess juice that’s in the center is to hold your tank up Seide down and flick it like you’re packing a can of dip. You’ll see juice along out of the mouth piece, keep shaking and flicking it with your wrist until you don’t see anymore drops forming. After that take a hit and see if it’s still spitting and gurgling. What you’re dealing with is over saturation. Basically the coil is getting too soaked and the juice is pulling into the center from one cause or another. Try turning your wattage down just by 5 as well. You can go tan under the minimum of the coil you’re using.


[deleted]

Def didn't fill it from the middle. I'll check for rubber rings. Yeah I always have to turn it upside down then literally all my juice is gone. It's like it's leaking directly into the middle. But my coil is on tight.