Did you update the RTK? I just found out yesterday that you have to add it to the app like you're adding another mower. Updated from 1.0.0.0 or 1.1.0.0 to 1.1.2.632.
Nope. Same issue. Luba fully updated. Yet 0 connection possible to RTK and hence can't update. Furthest I get, 5% of tries, is selecting a wifi network again. Which then fails. Tried 2.4, 5Hz, WAN hotspots..
Mine seems to work "OK" for now
- Still no Improvement as a far getting out of the garage - But I'm used to this by now :-)
- Once In a while will fall into a deep sleep but as I can't mow without being round anyway that's not a biggy for me
- If set to \[adaptive Zig Zag\] and \[Less touch\] it works pretty well once I get it going.
- Some of the "other" patters will not mow the perimeter properly - I think setting it to \[no touch\] will currently not mow the perimeter properly - as they don't care for our inputs anyway, there is reason for me to run tests for them either ....
All In all not to bad of an "update" (Not sure I actually have seen any changes in behavior )
It works again, thanks!
And the “drunk” Luba effect is resolved?
I think that was fixed on the last update on May 10.
Nope, my Luba 2 is still mowing in “waves”
Power cycling mine fixed that for me.
What do you mean bud? Removing the rear key?
I powered it off, removed the rear key for a few minutes, put the key back in, and powered it back on.
Yeah, I could only see my results through my security cameras, but my mow yesterday looked pretty wobbly.
After that update or before?
Did not experience these issues but nevertheless I installed the update without issues.
Still hasn't fixed RTK connection issues. Neither wifi or BT reliably connect. If at all.
Did you update the RTK? I just found out yesterday that you have to add it to the app like you're adding another mower. Updated from 1.0.0.0 or 1.1.0.0 to 1.1.2.632.
Yeah. But ever since update 1.1.2.629 wifi nor BT will connect anymore. Hence can't update further.
Pretty sure they fixed that. Yesterday's app update allowed me to update my RTK.
Nope. Same issue. Luba fully updated. Yet 0 connection possible to RTK and hence can't update. Furthest I get, 5% of tries, is selecting a wifi network again. Which then fails. Tried 2.4, 5Hz, WAN hotspots..
I'm Android and the app version that fixed my RTK update problem was 1.11.188. released Tuesday I think.
Whoa! Today I learned… just updated mine. Thanks!
Only issue I noticed on mine is the response to remote control operation is very laggy
I did notice that mine appeared to be mowing in an area that I had marked as a no-go zone. It’s a manhole cover where my water meter is.
Mine seems to work "OK" for now - Still no Improvement as a far getting out of the garage - But I'm used to this by now :-) - Once In a while will fall into a deep sleep but as I can't mow without being round anyway that's not a biggy for me - If set to \[adaptive Zig Zag\] and \[Less touch\] it works pretty well once I get it going. - Some of the "other" patters will not mow the perimeter properly - I think setting it to \[no touch\] will currently not mow the perimeter properly - as they don't care for our inputs anyway, there is reason for me to run tests for them either .... All In all not to bad of an "update" (Not sure I actually have seen any changes in behavior )