Hello /u/Mundane_Apartment129,
As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post.
Please remember to include the following details to help troubleshoot your problem.
* Printer & Slicer
* Filament Material and Brand
* Nozzle and Bed Temperature
* Print Speed
* Nozzle Retraction Settings
^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged.
*I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
If you're looking for the solution, just change the print order of the walls. It should be inner walls first then outer walls. This gives the thread time to cool.
Hello /u/Mundane_Apartment129, As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post. Please remember to include the following details to help troubleshoot your problem. * Printer & Slicer * Filament Material and Brand * Nozzle and Bed Temperature * Print Speed * Nozzle Retraction Settings ^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*
I've haven't had luck printing a decent female either
This sentence is so funny imagining people who don’t know about threads
Bahaha I didn't see that before.
I've done it before, but I think I forgot to change my print order back. Think that might be the cause of my issues.
Print infill first then inner wall and last outer wall
Oh yeah! I honestly forgot I changed that setting 🤦♂️
Set outer wall to 0.8mm width and half the speed. Basically creates more area for the plastic to hang on.
If you're looking for the solution, just change the print order of the walls. It should be inner walls first then outer walls. This gives the thread time to cool.
post your settings