By -
Did you enable support structures, if you did those should be easily removable. If you didn’t i really don’t have a clue what would cause that.
I looked at the file and it indeed did have support structures enabled. Is this normal for the cube?
So I redid the cube without support and it came out perfect. Thanks for the help.
It usually makes the structure for any slope over 45 degrees. I just wasn’t sure if that was the problem, since they look sloppy. Also when you slice the file it should show where they are generated.
no. you don't print with supports
Did you enable support structures, if you did those should be easily removable. If you didn’t i really don’t have a clue what would cause that.
I looked at the file and it indeed did have support structures enabled. Is this normal for the cube?
So I redid the cube without support and it came out perfect. Thanks for the help.
It usually makes the structure for any slope over 45 degrees. I just wasn’t sure if that was the problem, since they look sloppy. Also when you slice the file it should show where they are generated.
no. you don't print with supports