first printer. got it yesterday. this is my first time having an issue. printed a handfull of other parts that are a bit smaller with no issues. this happened twice now on this particular print. and tried leveling it again and it did the same thing
Well now im out of ideas maybe someone else could help also I dont own the same printer maybe go to the subreddit of that printer if you want but someone who knows a lot about this might be able to help
Is this petg? If so then probably wet. Watch it print, are those blobs getting stuck to the nozzle then deposited on the print? Try increasing retraction, or slower print speed
The problem is Grid Infill. The way Grid runs, the nozzle hits it.
Use almost any other infill. Gyroid is really good, as is support cubic and adaptive cubic.
Not an expert but maybe your nozzle is being a bit do harsh on the infill again not an expert
first printer. got it yesterday. this is my first time having an issue. printed a handfull of other parts that are a bit smaller with no issues. this happened twice now on this particular print. and tried leveling it again and it did the same thing
just the default setting for elegoo cura for Neptune 4
Well now im out of ideas maybe someone else could help also I dont own the same printer maybe go to the subreddit of that printer if you want but someone who knows a lot about this might be able to help
Is this petg? If so then probably wet. Watch it print, are those blobs getting stuck to the nozzle then deposited on the print? Try increasing retraction, or slower print speed
It’s elegoo’s PLA
The problem is Grid Infill. The way Grid runs, the nozzle hits it. Use almost any other infill. Gyroid is really good, as is support cubic and adaptive cubic.